Kanger 1.8 Ohm Replacement VOCC BDC 5pk
Category: Accessory  Publish Time: 2015-11-08 11:52 

Kanger 1.8 Ohm Replacement VOCC BDC 5pk
Kanger 1.8 Ohm Replacement VOCC BDC 5pk
Kangertech 1.8 Ohm Replacement VOCC Bottom Dual Coil 5 Pack
These are replacement bottom dual coils that are made for the Kangertech bottom dual coil tanks and clearomizers. Bottom dual coil tanks and clearomizers provide a nice warm vapor, with a superb clean flavor, and reduced wicking issues. This is due to the bottom coil design. These coils vape great and are versatile because they work with most of the Kangertech bottom dual coil tanks and clearomizers including but not limited to the Evod 2, the Protank 3, the Mini Protank 3, the T3D, and the Aero Tank.

This is for a Pack of 5 Replacement coils only.

Kanger 1.8 Ohm Replacement VOCC BDC

Please note these coils are not compatable with other bottom coil tanks made by manufactureers other than kangertech.  

All items are Dual coil.  1.5 Ohm coils may not work with all devices because of their low resistance.

 

Kangertech 1.8 Ohm LR Replacement Bottom Dual Coil

1.8 ohm LR (Low Resistance) coil. Manufactured by Kangertech. Testing shows a nice consistent vape at 3.7 volts.

kangertech 2.0 Ohm Replacement Bottom Dual Coil

2.0 ohm coil . Manufactured by Kangertech. Testing shows a nice consistent vape at 3.7 and 5 volts.

  

Please read our 'Terms and Warranty' info before purchasing Replacement Coils.

 

Low Resistance (LR) Replacement Coil (approx. 1.8 ohms): These Coils have a lower resistance than regular Coils. LR Coils run hotter and create more vapor than regular Coils. They are meant for use with regular 3.7V batteries. We do not recommend using them with a high voltage (6V-7.4V) setup; this will shorten the lifespan of the LR Coil significantly.

 

Useful Tip:

It is always a good idea to have a spare Replacement Coils!

Cleaning your Replacement Coil

There are many methods for cleaning, some more successful than others. “Blowing out” the coil is usually the first recommendation and can fix many issues on the fly. As mentioned above as a fix for a flooded coil, simply remove the coil from the tank or clearomizer. Place your lips on the top end of the coil and blow firmly to push the excess liquid or gunk onto a paper towel from the top end.   However, if this does not fix the problem try one of the following methods:

 

Hot Water Rinse – This method works sometimes to fix minor problems

  1. Run under VERY hot water.
  2. "Blow out” coil to remove excess water.
  3. Set upright and allow to dry for 24 hours, or use a hairdryer for 3-5 minutes.

Soaking/Baths – Most recommended and common method, will fix many problems, but takes time.

  1. Soak in hot water for at least 30 minutes and up to 24 hours, or soak in Boiling water for 5-10 minutes. Remove with tongs and let cool down.
  2. "Blow out” coil to remove excess water.
  3. Set upright for 24 hours or use a hairdryer for about 3-5 minutes to dry the coil.

ٶӣ ϶[www.hg888a1.com/wsdq/] ֳ[www.365guipian.com/a/a/eleboyulecheng/] [www.905555.com/] Żƽ[www.marry52.com/amhjc/] Ǯţţ[www.jstv.com.cn/zhenqianniuniu49/] 888˶IJ[www.dxszbw.com/qywv/] ȫѶʱ[www.dangkai.com/mlrr6/] Ͽ[www.kj0788.com/] Ͼ[www.hg999a1.com/amxpj/] Ǯ[www.yxjyj.com/zhenqianyule/]